Survivalist Forum banner

1 - 14 of 14 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
Hi everyone just wanted to share what I do here at SAR Global Tool. Here is some recent work.

Hope you enjoy

Thanks
SAR

This design is a simple utility knife in cpm 154 stainless called the PBK pack and boat knife





This one is a 1095 or CPMD2 S/E ( survive/escape )

1095







CPMD2





SAR Kukri in cpm 154



 

·
I see a bad moon arising
Joined
·
1,267 Posts
NICE. :thumb:

Is that a pry-bar end on the knife in the second picture?
(Can't tell if the photo is fooling me -- maybe a bent pry-bar
end, or maybe just a bevel line.)

And that's some wicked-crazy work on the Kukri's.
Fully sharpened second edge? And is that cresent-shaped
bevel near the guard also a cutting edge? Looks like an
excellent cutting notch where more control over the cut
is needed.

Very nice. Any of it for sale?
 

·
Registered
Joined
·
13 Posts
Discussion Starter #3
NICE. :thumb:

Is that a pry-bar end on the knife in the second picture?
(Can't tell if the photo is fooling me -- maybe a bent pry-bar
end, or maybe just a bevel line.)

And that's some wicked-crazy work on the Kukri's.
Fully sharpened second edge? And is that cresent-shaped
bevel near the guard also a cutting edge? Looks like an
excellent cutting notch where more control over the cut
is needed.

Very nice. Any of it for sale?
Thanks Varmit

Yes its a small pry bar detail...good for pulling staples from target boards, small nails etc...just light duty work.

Those kukri's are double edge more in line with a fighting type, the crescent is not sharpened but that's been a consideration. I am in the process of building 8 more kukri's this month and they will be of different designs throughout.

Here are the last 2 kuk's done







I have sent Kev a few pm's about a merchant account no reply yet, so until then I will not attempt to sell my work just show folks what I do. I make other high quality survival gear as well and would like to turn folks here on to it.

Thanks again
SAR
 

·
Registered
Joined
·
13 Posts
Discussion Starter #14
Nice work, especially like you first kukhris but then I'm a goner when it comes to chisel ground blades.
LOL! thats a double hollow and the tip is flat ground on that kukri, that was a special order for what is called a compound grind. I do make some chisel ground knives and they have some really good application's, not many but they do work well.

Thanks everyone
SAR
 
1 - 14 of 14 Posts
Top