Survivalist Forum banner

1 - 6 of 6 Posts

·
Average Joe
Joined
·
277 Posts
Discussion Starter #1
Well it's been a month since I had to take apart my shotgun. I was about take it to a gunsmith to reassemble it because I thought my breech bolt would not go into the gun. Last night I realized that it wasn't that, it was the one of the action bar of the forend tube assembly was bent. The problem is the the left bar won't go back into the hole but the right bar is fine.

I found new forend tube assembles for sale on the internet.

Here is my question which Remington 870 20 gauge forend assembly tubes will find my 20 gauge H&R Pardner Pump Compact ? :confused:

I known that all parts except the barrel are interchangeable.
 

·
Registered
Joined
·
339 Posts
I have a 982 which I understand is the same thing. The mag tube is longer than a standard 870. You're going to have to get service from their warranty people I think.
 

·
Average Joe
Joined
·
277 Posts
Discussion Starter #6
Found Action Bar Assembly.

I don't any more help now.

I found an the specific action bar assembly for my shotgun for $21.85 on gunpartscorp.com

Thanks all for the suggestions. :D:
 
1 - 6 of 6 Posts
Top