Survivalist Forum banner

1 - 4 of 4 Posts

·
Strength and Honor
Joined
·
290 Posts
Discussion Starter #1 (Edited by Moderator)

·
Banned
Joined
·
4,937 Posts
Try Enterprise Arms in Irwindale Ca.
The make FAL's/L1A's also.
I think their prices may be better.
Quality is very high. They make their own recievers.

Their standard FAL is 999.00

http://www.entreprise.com/

They've had lots of write-ups in magazines, which are viewable on their website.

T
 

·
Registered
Joined
·
559 Posts
The main differances are:
STG-58 has been built from a parts kit with a new barrel and DSA made reciever. Most of the parts kits seem to contain unused internals. The internal parts on on mine looked brand new when I purchased my rifle. Others have stated that their internals looked used but they have not had any issue.

The STG-58 also have steel handguards and bipods. The steel handguards heat up rather quickly so I replaced mine with a set of DSA plastics for $40 and have not had an issue. This swap requires only a screwdriver.

The SA-58 is an entirely new gun, whether this is worth the $500 increase is debatable to some people. I personally would rather spend less and buy a spare spring set from tapco for $20 and a spare bolt,firing pin and extractor from DSA.
 

·
Strength and Honor
Joined
·
290 Posts
Discussion Starter #4
Thanks, exactly what I was looking for. I completely agree with your assessment on the value. I'm looking to add a FAL to the arsenal soon.
 
1 - 4 of 4 Posts
Top