Survivalist Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
does anyone know of any parts i can buy to take the rattle out of the receiver on my DPMS ar15.it doesnt rattle much but its because the two halves (upper and lower) dont fit together tight enough it didnt have this problem before i think it because of so many field stripings.any help would be highly appreciated,thanks
 

·
FMJ trigger job
Joined
·
103 Posts
You can also put a 3/8 oring around the front pen post. You will have to replace it everytime you open the rifle because when you close the gun it will cut it. But it will tighten up the action. I have a rifle that is new but very loss and i put an o ring on it and it went from 2" groups down to less than an inch.
 

·
Opinionated old fart.
Joined
·
8,046 Posts
The accu-wedge will increase wear on the pins by putting tension on them. Rattle is normal and does not affect accuracy.
 
1 - 6 of 6 Posts
Top