Ok anyone have pic's of comments on a good mounting of the press.
I have a craftsman project center 5 draws and power strip on wheels. How you think that would work? I also have a 8 foot work bench but it is normally full of chainsaw parts.
I have limited space, so I installed mine on a 2x8 piece of lumber and c-clamp it with several c-clamps on my desk in the home office. The good thing about this is that since the board is long, I can use drill bits to drill out small holes to put casings in.
I found an old desk on the side of the road to bolt my press to in my old rental town house basement.
Not pretty but did the job.
Since moving to the new house, I haven't unpacked the press yet.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Survivalist Forum
11.6M posts
167.1K members
Since 2007
A forum community dedicated to survivalists and enthusiasts. Come join the discussion about collections, gear, DIY projects, hobbies, reviews, accessories, classifieds, and more!